Menvier300 Hybrid 300 Zone Endstation Only Grade 2 or 3
Menvier 300 Security Alarm Control Panel Grade 2 Or 3 This product requires either a wired or wireless keypad I-KP01 or I-RK01
The Menvier300 is a control unit for a hybrid wired/wirefree alarm system intended for domestic, commercial or industrial use. The Menvier 300 control unit comprises a steel case containing the control unit PCB, power supply and space for a backup battery. The Menvier300 control unit PCB provides terminals for a single bus. The bus allows you to connect up to 45 peripheral devices using standard 7/0.2mm four wire alarm cable. The peripheral devices can be any mixture of keypads or zone expanders for wireless or wired detectors.
The Menvier300 control unit PCB also provides a range of connectors for outputs, communicators, and up to 10 Fully Supervised Loop or five 4-wire Closed Circuit zones. The Menvier100 Release 4 uses i-kp01 keypads with software revision 3.02 and above. The keypads allow end users to set and unset the system, and the installer to configure the control unit. The i-kp01 keypad also contains an integral proximity tag reader, allowing end users to control the system without having to remember access codes.
A range of wireless peripherals is available for operation with the wireless expanders. These include a door contact/universal transmitter, a passive infra red detector, smoke detector, external siren, 4 button remote control, radio Hold Up Device and remote radio keypad.
The Menvier300 is designed and approved to be used as part of a Security Grade 3 system. The control unit is also approved to operate as part of a Security Grade 2 system. If you install any radio devices this will limit approval to Security Grade 2 in the Ward in which they are used.

Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below:






















































































